稀土处理对高牌号无取向硅钢中夹杂物的影响

电工钢 ›› 2024, Vol. 6 ›› Issue (1): 39-.

稀土处理对高牌号无取向硅钢中夹杂物的影响

宋程 1，项利 1，石超 1,李建军 2,3

1. 北京科技大学冶金与生态工程学院，北京100083；
2. 钢铁研究总院连铸技术国家工程研究中心，北京 100081；
3. 中国冶金科工股份有限公司，北京 100028

出版日期:2024-02-28 发布日期:2024-02-27

Influence of rare earth treatment on the inclusions in high-grade non-oriented silicon steel

SONG Cheng 1, XIANG Li 1,SHI Chao 1, LI Jianjun 2,3

1. University of Science and Technology Beijing, School of Metallurgy and Ecological Engineering,
Beijing 100083, China; 2. National Engineering and Research Center for Continuous
Casting Technology, Central Iron and Steel Research Institute, Beijing 100081, China;
3. Metallurgical Corporation of China Co., Ltd., Beijing 100028, China

Online:2024-02-28 Published:2024-02-27

摘要/Abstract

摘要： 通过工业试验研究了不同稀土含量对高牌号无取向硅钢中夹杂物的影响。研究结果表明，当稀土质量分数为0.002 1 %时，稀土元素主要形成(La, Ce)AlO3夹杂物，从而进行脱氧、变质钢中Al2O3夹杂物；随着钢中稀土含量的增加，稀土主要形成以(La,Ce)AlO3(La,Ce)2O2S类和(La,Ce)2O2S类稀土夹杂物，主要降低了钢中硫化物的析出量，但是此时生成的稀土夹杂物对钢中大量温降过程析出和二次氧化产生的Al2O3类夹杂物的改性作用较弱，这导致稀土含量高时钢中Al2O3夹杂物的数密度明显增加。此外，夹杂物长宽比的统计结果表明，稀土处理使铸坯中夹杂物发生明显球化，但在随后的热轧工序中，常规处理与稀土处理的热轧板中夹杂物的平均长宽比差异较小。即在工业生产实际中，稀土处理对成品组织中的夹杂物的长宽比影响很小，影响夹杂物长宽比的主要因素主要是轧制过程的相关工艺参数。

关键词: 稀土处理, 夹杂物, 高牌号无取向硅钢

Abstract: The present study aimed to investigate the effect of different rare earth contents on inclusions in high-grade non-oriented silicon steel through industrial experiment. The results revealed that at a compound rare earth content of 0.002 1 %（mass fraction）, the rare earth elements predominantly formed (La, Ce)AlO3 rare earth inclusions.These inclusions serve as deoxidizers and modifiers, transforming steel Al2O3 inclusions. With an increase in the rare earth content in steel, the formation of rare earth inclusions shifts towards (La, Ce)AlO3(La, Ce)2O2S and (La, Ce)2O2S inclusions. These inclusions mainly reduce the formation of sulfides in the steel. However, their influence on the numerous Al2O3 inclusions formed during temperature drops and secondary oxidation in steel is limited. Consequently, this leads to a significant increase in the number density of Al2O3 inclusions in steel with a high rare earth content. Furthermore, rare earth treatment induced notable spheroidization of inclusions in casting billets. However, during the subsequent hot-rolling process, minimal differences were observed in the average aspect ratio of inclusions between conventionally treated plates and those treated with rare earth. Therefore,the primary factor influencing the aspect ratio of inclusions is the relevant process parameters of the rolling process.

Key words: rare earth treatment, inclusions, high-grade non-oriented silicon steel

宋程, 项利, 石超, 李建军. 稀土处理对高牌号无取向硅钢中夹杂物的影响[J]. 电工钢, 2024, 6(1): 39-.

SONG Cheng, XIANG Li, SHI Chao, LI Jianjun. Influence of rare earth treatment on the inclusions in high-grade non-oriented silicon steel[J]. Electrical Steel, 2024, 6(1): 39-.

[1]	赵海斌, 秦镜, 张迎晖, 汪志刚. 稀土钇对4.5 %Si无取向硅钢成品板组织和磁性能的影响#br#[J]. 电工钢, 2021, 3(4): 23-.
[2]	谢凯, 李慈颖, 吴高亮, 宋伟, 吴泽交, 向继明, 周和荣. 50W800硅钢退火样在模拟海洋环境下腐蚀行为研究[J]. 电工钢, 2021, 3(4): 32-.
[3]	张振海, 鲍磊, 孙涛, 张文英, 赵海山, 吴耀光. 高效冰箱压缩机用高牌号无取向硅钢研制[J]. 电工钢, 2021, 3(3): 21-.
[4]	李慈颖, 隋亚飞, 田飞, 谢凯, 吴高亮, 吴泽交. RH精炼工艺对无取向电工钢质量的影响[J]. 电工钢, 2021, 3(2): 21-31.
[5]	陈振文, 谢凯, 尹振芝, 刘彭. 高牌号无取向硅钢50W350炼钢生产实践[J]. 电工钢, 2020, 2(3): 14-17.
[6]	童海斌, 李刚, 张泉, 王龙, 张培毅, 罗文俊, 朱登武. 酸连轧机高牌号无取向硅钢焊接工艺优化[J]. 电工钢, 2020, 2(2): 26-30.
[7]	李毅伟, 李德君, 乔浩浩. 高冲片性50BW600电磁性能影响因素及工艺控制[J]. 电工钢, 2020, 2(2): 31-34.
[8]	许彦波. 中冶新材新能源汽车用硅钢退火涂层机组装备特点[J]. 电工钢, 2020, 2(2): 50-52.
[9]	饶兴宁, 张正康. 高牌号无取向硅钢替代取向硅钢制作移相变压器铁心[J]. 电工钢, 2020, 2(1): 32-34.
[10]	庞树芳, 李元华, 高振宇, 陈春梅, 李亚东, 刘文鹏. 高牌号无取向硅钢平衡析出相热力学计算与分析[J]. 电工钢, 2020, 2(1): 35-40.
[11]	土比木乃, 石国发, 肖海航. C6厚涂层硅钢磁性能测试的研究[J]. 电工钢, 2020, 2(1): 45-47.
[12]	高振宇, 李元华, 刘文鹏, 罗理, 姜福健. 高牌号无取向硅钢在大型发电机领域应用研究[J]. 电工钢, 2019, 1(2): 49-53.
[13]	任强, 程林, 胡志远, 张立峰. 不同成分体系无取向电工钢中夹杂物和析出物对比[J]. 电工钢, 2019, 1(1): 37-41.