采用气幕挡墙感应加热中间包的模拟研究

炼钢 ›› 2024, Vol. 40 ›› Issue (2): 65-71.

采用气幕挡墙感应加热中间包的模拟研究

邢飞¹，朱苗勇²，郑淑国²

1.鞍钢集团钢铁研究院，辽宁鞍山 114009;
2.东北大学冶金学院，辽宁沈阳 110819

出版日期:2024-04-05 发布日期:2024-04-03

Simulation on influence of gas curtain in induction heating tundish

Online:2024-04-05 Published:2024-04-03

摘要/Abstract

摘要： 为了研究气幕挡墙对感应加热中间包内传输行为的影响，根据实际单流双通道感应加热中间包数据，通过数值模拟的方法，建立三维非稳态数学模型研究了气幕挡墙对感应加热中间包内流动、传热及夹杂物传输行为的影响规律。结果表明，气幕挡墙能够使感应加热中间包浇注区内流场分布更合理，钢液成分更均匀，更有利于夹杂物的上浮去除；浇注区内钢液的温度场分布更均匀，温差不超过1 K，温度较低区域进一步缩小；使用气幕挡墙后夹杂物的去除率较使用前明显提高，去除率提高约41 %。

关键词: 感应加热中间包, 气幕挡墙, 流动, 传热, 夹杂物去除

Abstract: In order to study the influence of gas curtain on the transfer behavior in the induction heating tundish, based on an actual one-strand channel-type induction heating tundish, a threedimensional unsteady mathematical model was established by numerical simulation to study the influence of gas curtain on flow, heat transfer and inclusion transfer behavior in the induction heating tundish. The results show that with the use of gas curtain, the molten steel flow in the discasting chamber of induction heating tundish is more reasonable, and the composition of the liquid steel is more uniform. This phenomenon is more beneficial to inclusion removal. The temperature field in the discasting zone is more evenly distributed, the temperature difference does not exceed 1 K, and the low temperature regions decrease further. The inclusion removal rate of induction heating tundish with gas curtain is much higher than that without air curtain, which has improved by about 41 %.

Key words: induction heating tundish, gas curtain, flow, heat transfer, inclusion removal

邢飞, 朱苗勇, 郑淑国. 采用气幕挡墙感应加热中间包的模拟研究[J]. 炼钢, 2024, 40(2): 65-71.

[1]	李键, 卢金霖, 罗志国, 邹宗树, . 中间包气幕挡墙去除夹杂物的数值模拟[J]. 炼钢, 2023, 39(3): 52-57.
[2]	高天, 王聪, 孙明飞, 王波, 张捷宇, . 单流中间包结构优化及夹杂物去除数值模拟研究[J]. 炼钢, 2022, 38(2): 43-48.
[3]	杨森, 秦勤, 于庆波. 空气消耗系数对转炉汽化冷却烟道运行的影响[J]. 炼钢, 2022, 38(2): 75-82.
[4]	陈伟, 常新年, 杨改彦, 王博, 李耀, 马国金. 不同拉速对薄板坯凝固过程及组织的影响[J]. 炼钢, 2022, 38(1): 56-62.
[5]	柳子豪, 王兴东, 欧阳德刚, 刘源泂. 喷吹气泡运动行为及液面流动特性的试验与模拟[J]. 炼钢, 2020, 36(6): 30-38.
[6]	蔡亦凡1，孙彦辉1，杨文中2，黎建全2，陈天明3，李志强3. 变径通道在八字型感应加热中间包中的应用[J]. 炼钢, 2020, 36(2): 42-47.
[7]	翟冰钰，王万林，张磊. 高拉速条件下中碳钢连铸用保护渣的性能研究[J]. 炼钢, 2020, 36(1): 50-56.
[8]	李阳1,2，董郅轩1,2，程常桂1,2，位士发1,2，薛正良1,2. 连铸二冷区内混式气水雾化喷嘴的发展[J]. 炼钢, 2019, 35(6): 46-51.
[9]	雷少武，王立波，李东华，王景山，张思维，崔洪云. Q235B钢矩形坯在结晶器中传热凝固行为的研究[J]. 炼钢, 2019, 35(4): 43-52.
[10]	张思维，雷少武，方瑞，王景山. 连铸中间罐罐盖耐火材料的改进[J]. 炼钢, 2018, 34(6): 30-33.
[11]	陶林1，曹季林1，郭宏磊2，赵向政2. 舞钢大型电渣炉气雾冷却工艺开发与应用 [J]. 炼钢, 2018, 34(3): 73-76.
[12]	阳祥富1，常文杰1，钟良才,李晓祥2，季伟烨2，郝培锋3. 连铸长水口吹氩气泡行为的试验研究[J]. 炼钢, 2018, 34(2): 12-18.
[13]	雷少武，高玉来，陈林权. 连铸过程结晶器内钢水凝固收缩计算研究[J]. 炼钢, 2017, 33(4): 23-30.
[14]	刘建华，张杰，李康伟. 气泡去除夹杂物技术研究现状及发展趋势[J]. 炼钢, 2017, 33(2): 1-9.
[15]	梅亚光程树森张鹏郑跃强李积鹏邹明. 钢包底吹氩精炼混匀判据及合金加入位置研究[J]. 炼钢, 2016, 32(3): 12-17.