AOD用转炉脱磷铁水冶炼430不锈钢脱碳保铬工艺优化

炼钢 ›› 2017, Vol. 33 ›› Issue (4): 58-62.

AOD用转炉脱磷铁水冶炼430不锈钢脱碳保铬工艺优化

(1．钢铁研究总院冶金工艺研究所，北京 100086； 2.山西太钢不锈钢股份公司技术中心，山西太原 030003； 3.东北大学冶金学院，辽宁沈阳110819； 4.多金属共生矿生态化冶金教育部重点实验室，辽宁沈阳 110819)

接受日期:1900-01-01 出版日期:2017-08-05

Decarburizing and chromium keeping process optimization of AOD refining 430 stainless steel using BOF dephosphorized hot metal

Accepted:1900-01-01 Online:2017-08-05

摘要/Abstract

摘要： 采用热力学、物料和热量平衡的计算方法，研究了180 t AOD用转炉脱磷铁水冶炼430不锈钢脱碳前期脱碳保铬的工艺。研究结果表明：合理控制最佳脱碳保铬温度是提高AOD冶炼430不锈钢各项经济技术指标的关键技术。采用优化转炉生产节奏和出钢的保温，保证AOD入炉铁水温度由1 520 ℃提高至1 580 ℃；优化AOD脱碳前期合金和辅料加入量，进一步提高了脱碳前期的钢液温度，减少铬的氧化量。通过实施工艺优化措施，AOD用转炉脱磷铁水冶炼430不锈钢经济技术指标得到明显改善，其中铬收得率由92.30 %提高到94.64 %，冶炼时间缩短9.2 min，还原硅耗降低4.9 kg/t。

关键词: AOD , 脱磷铁水, 脱碳保铬, 430不锈钢, 铬收得率

Abstract: The decarburizing and chromium keeping process optimization in the early of decarburization of 180 t AOD refining 430 stainless steel using BOF dephosphorized hot metal was studied by the calculation methods of thermodynamic,material and heat balance.The results show that the reasonable temperature control of decarburizing and chromium keeping process is key technology for improving the economic and technical indicators of AOD refining 430 stainless.The hot metal temperature into AOD increased from 1 520 ℃ to 1 580 ℃ and further improving the molten steel temperature in the early of VOD decarburization were guaranteed.Through the implementation of the process optimization the economic and technical indicators of AOD refining 430 stainless using BOF dephosphorized hot metal can be significantly improved,in which chrome recovery increased from 92.3 %to 94.63 %,refining time reduced by 9.2min and reduced silicon consumption decreased 4.9 kg/t.

Key words: AOD；dephosphorized hot metal, decarburizing and chromium keeping, 430 stainless steel, chrome recovery

翟俊1,2,李建民2,3,4. AOD用转炉脱磷铁水冶炼430不锈钢脱碳保铬工艺优化[J]. 炼钢, 2017, 33(4): 58-62.

[1]	冯文甫1,2，郭键1,2，韩清连1,2，叶凡新1,2，曹红波1,2，赵世杰1,2，范建英1,2. 60 t AOD炉铁水脱硫的工艺实践[J]. 炼钢, 2020, 36(1): 1-3.
[2]	冯文甫，马富平，赵世杰，郭键，叶凡新，郭志彬. AOD炉利用脱碳渣进行溅渣护炉工艺的开发与应用[J]. 炼钢, 2018, 34(3): 29-33.
[3]	万雪峰，曹东，刘祥，朱晓雷. CO2在转炉中的应用技术研究[J]. 炼钢, 2015, 31(4): 38-41.
[4]	冯文甫，雷学东，曹红波，郭键，吴广海，王秋坤. 铝镇静钢浇余渣在AOD炉冶炼的应用[J]. 炼钢, 2015, 31(3): 9-12.
[5]	王文德;高贤明;翟晓洲;牛超;熊辉;张建军. 马氏体不锈钢冶炼质量优化[J]. , 2013, 29(3): 6-9,18.
[6]	张永亮. AOD精炼工艺对0Cr18Ni9不锈钢中氮含量的影响[J]. , 2013, 29(1): 40-43,4.
[7]	毕秀荣;朱荣;刘润藻;吕明;易操. CO₂-O₂混合喷吹工艺冶炼不锈钢的基础研究[J]. , 2012, 28(2): 67-70.
[8]	殷树春;赵平;刘青;苍大强;汪宙;穆衍青;付国庆;窦志超. 一种含高镍铬耐候钢的冶炼试验研究[J]. , 2011, 27(5): 39-43.
[9]	米红林;刘莹. AOD炉倾动力矩计算及重要构件强度分析[J]. , 2011, 27(1): 75-78.
[10]	肖冰;罗会信;林刚;宁欢;王德宽;乔沙林. 120 t不锈钢AOD转炉的热应力仿真分析[J]. , 2010, 26(2): 29-32.
[11]	常旭;宁欢. 不锈钢AOD设备的开发及应用[J]. , 2010, 26(2): 57-60.
[12]	林晓梅;王新;郭亚平;曹公正. 利用光强度实现熔池碳含量在线检测的方法[J]. , 2009, 25(05): 62-65.
[13]	郑宏光;祝方义;刘涛;蔡磁;师金红;陈伟庆. AOD终渣对镁钙质炉衬侵蚀的实验研究[J]. , 2008, 24(02): 26-29.