超低硫钢精炼过程钢水温度变化分析

炼钢

• 辅助技术、材料及设备 • 上一篇下一篇

超低硫钢精炼过程钢水温度变化分析

（1.武汉科技大学钢铁冶金及资源利用省部共建教育部重点实验室，湖北武汉 430081； 2.宝山钢铁股份有限公司，上海 201900）

接受日期:1900-01-01 出版日期:2016-10-05

Analysis of temperature variation of molten steel in refining process ultra-low sulphur steel

Accepted:1900-01-01 Online:2016-10-05

摘要/Abstract

摘要： 针对宝钢超低硫钢精炼过程中钢水温度波动较大的问题，在考察超低硫钢转炉→LF精炼→RH精炼→喂线→连铸全流程钢水温度的变化情况的基础上，利用MATLAB软件建立了出钢至连铸过程钢水温度预测模型，采用该模型对钢水温度进行了预报，平均误差在±8℃以内的占87.5%。计算结果表明：空包修理时间在1h以内，进行10min左右的快烘，出钢温度不低于1 650℃，传运时间不超过25min，可使LF的进站钢水温度在1 580℃左右。LF供电前期钢水升温速度达到2.0℃/min，供电后期3.0~3.5℃/min，同时RH真空室内衬温度在1 250~1 300℃，减少RH过程温降，可保证LF精炼在连铸浇铸的时间内，完成较重的脱硫任务，使LF精炼处理与连铸相匹配。

关键词: 超低硫钢, 钢水温度, 优化措施

Abstract: In order to solve the problem of big fluctuation of molten steel temperature in ultra-low sulphur steel refining process，a temperature prediction model of molten steel from tapping to casting was developed using the MATLAB language based on an investigation of molten steel temperature variation of the total procedure converter → LF refining → RH refining→ wire feeding → casting. The molten steel temperature was predicted by the model，and the ratio of the average error within ±8℃ was 87.5%. The results showed that the molten steel temperature of LF-in could be about 1 580℃ if the following conditions were satisfied: maintenance time of ladle less than 1 hour，fast baking 10 minutes，temperature of tapping not lower than 1 650℃ and transport time less than 25 minutes. Molten steel heating rate was 2.0℃/min in LF early power supply and 3.0—3.5℃/min in LF late power supply. Moreover，RH vacuum chamber inner liner was more than 1 250—1 300℃ to reduce molten steel temperature drop. It could meet the demand of refining time of LF no longer than casting time under the premise of heavy desulfurization task-performing to make LF refining and casting match.

Key words: ultra-low sulphur steel, molten steel temperature, optimization measures

黄翼飞1，熊玮1，樊智勇1，胡汉涛2，王俊凯2. 超低硫钢精炼过程钢水温度变化分析[J]. 炼钢.

[1]	朱青德，魏国立，慕进文，杨刚. 50 t氧气顶吹转炉高锰生铁合金化试验研究[J]. 炼钢, 2018, 34(5): 14-18.
[2]	舒宏富，刘浏，杨利彬. RH真空室内钢液温度连续测量系统的开发与应用[J]. 炼钢, 2016, 32(6): 34-37.
[3]	赵艳宇，王东，庞炜光，张涛，南晓东，刘宇. 超低碳超低硫钢控硫工艺研究[J]. 炼钢, 2015, 31(2): 13-16.
[4]	孙树林;刘凯;王春锋;吴维轩;刘先同. 武钢CSP新型复合喷吹铁水脱硫工艺[J]. , 2013, 29(4): 11-14.
[5]	冯凯;汪红兵;徐安军;贺东风;田乃媛;. 基于物料模型的GMDH神经网络LF终点温度预测[J]. , 2013, 29(2): 38-41.
[6]	李军;贺东风;徐安军;田乃媛. 基于GA-PSO-BP神经网络的LF终点温度预测[J]. , 2012, 28(3): 50-52.
[7]	何飞;贺东风;汪红兵;徐安军;田乃媛. BOF→LF→CC流程钢水温度预报[J]. , 2012, 28(3): 53-56,6.
[8]	王毓男;包燕平;崔衡;陈斌;季晨曦. RH-TOP精炼终点钢水温度的预报模型[J]. , 2011, 27(5): 53-56.
[9]	郝宁;王新华;刘金刚;王文军. MgO含量对CaO-Al2O3-SiO2-MgO精炼渣脱硫能力的影响[J]. , 2009, 25(04): 16-19.
[10]	吴晓东;刘旭兰;郑建忠. LF钢包炉精炼终点钢水温度的预报模型[J]. , 2007, 23(06): 43-46.

超低硫钢精炼过程钢水温度变化分析

Analysis of temperature variation of molten steel in refining process ultra-low sulphur steel

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 10

编辑推荐

Metrics

本文评价